NEC IP4WW-12TXH-A TEL - Placing Calls; Place an Outside Call <Quick Access>; Place an Outside Call <Access by Code>; Place an Intercom Call <Dial Access>

5
Placing Calls
◼ Place an Outside Call <Quick Access>
 Listen to the Dial Tone before dialing a Telephone Number.
 You can have function keys for Trunks or Trunk Groups. Ask your NEC Authorized Supplier for the details.
◼ Place an Outside Call <Access by Code>
 To change the Trunk Access Code, ask your NEC Authorized Supplier for the details.
 Listen to the Dial Tone before dialing a Telephone Number.
 If the Trunk Group number is greater than 10, you should enter 2 digits (e.g. 11 : Group 11) after dialing
“704”. Ask your NEC Authorized Supplier for the details.
 Ask your NEC Authorized Supplier for the Trunk Number dialing digits.
◼ Place an Intercom Call <Dial Access>
 Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialing “1” changes voice/ring mode (if the destination is Multi-line Terminal).
? ? ? ?
Telephone Number
Trunk Key
(e.g. : 005 = Trunk No.5)
Trunk No.
? ? ?
# 0
Trunk Group No.
7 0 4 ?
?
?
?
Telephone Number
Trunk Access Code
0
Speaker
? ? ?
Extension Number
Speaker