NEC ITY-6D - Configuring Headset Mode

2. Thread the LAN cable through the groove on the bottom of the tilt
legs.
Figure 6: Thread the LAN cable through the groove
Configure a Headset
To utilize a headset, it must be enabled that the headset mode on the phone:
1. Press the “Menu” key.
2. Press
3. Press
4. Press
5. Press
“User Settings”.
“Headset”.
“Enable/Disable”.
“Enable”.
6. Press Enter on the cursor pad or the “OK” softkey to apply the setting.
7. Insert the headset cord plug into the HEADSET connector on the back of
the phone until it sounds a click.
Figure 7: Connect the headset cord plug to the phone
3
2
1
2
4