NEC M402H - [Options(2)]

103
5. Using On-Screen Menu
[OPTIONS(2)]
SelectingStandbyconditionin[STANDBYMODE]
Theprojectorhastwostandbymodes:[NORMAL]and[NETWORKSTANDBY].
The[NORMAL]modeisthemodethatallowsyoutoputtheprojectorinthepower-savingconditionwhichconsumes
lesspowerthanthe[NETWORKSTANDBY]mode.Theprojectorispresetforthe[NORMAL]modeatthefactory.
NORMAL �����������������������������POWER indicator: Red light/STATUS indicator: Off
When [NORMAL] is selected, only the following buttons and feature will work:
POWER button on the projector cabinet and the remote control, and powering on from PC Control
command�
NETWORK STANDBY ����������POWER indicator: Orange light/STATUS indicator: Off
When [NETWORK STANDBY] is selected, the projector can be turned on over a wired LAN connec-
tion and only the following buttons, port, and features will work:
POWER button on the projector cabinet and the remote control, powering on from PC Control
command, AUTO POWER ON(COMP�), LAN port, wireless LAN unit (optional), Virtual Remote Tool,
LAN feature, and Mail Alert feature�
Important:
- When[NETWORKSTANDBY]isselected,[AUTOPOWEROFF]willturngreyincolorandbedisabled,and[0:15]willbeselected
automatically.
NOTE:
• Evenwhen[NORMAL]or[NETWORKSTANDBY]isselectedfor[STANDBYMODE],poweronoroffcanbedonebyusingthePC
CONTROLport.
• ThepowerconsumptioninthestandbymodewillnotbeincludedincalculatingCO
2
emissionreduction.
• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.
EnablingDirectPowerOn[DIRECTPOWERON]
Turnstheprojectoronautomaticallywhenthepowercordisinsertedintoanactivepoweroutlet.Thiseliminatesthe
needtoalwaysusethePOWERbuttonontheremotecontrolorprojectorcabinet.