NEC M402H - Setting up the Projector for a Wireless LAN Connection (with the Optional USB Wireless LAN Unit Equipped) [WIRLESS LAN]

109
5. Using On-Screen Menu
Setting up the Projector for a Wireless LAN Connection (with the optional USB Wireless
LAN Unit equipped) [WIRLESS LAN]
Important
• Consultwithyournetworkadministratoraboutthesesettings.
• WhenusingawirelessLANconnection,attachtheoptionalUSBWirelessLANtotheprojector.(→page128)
[PROFILE] [DISABLE] WirelessLANconnectionwillbeturnedoff
[EASYCONNECTION] Select[EASYCONNECTION]toexecuteawirelessLAN
easilyusing ImageExpress UtilityLite onthe supplied
NECProjectorCD-ROM.
[SIMPLEACCESS
POINT]
Settheprojectorforsimpleaccesspoint.
Selecting[SIMPLEACCESSPOINT]willallowtheprojec-
tortocreateaninfrastructurenetwork.TheIPaddressof
theprojectorwillbesetautomatically.
Select"ObtainanIPAddressAutomatically"tosettheIP
addressofaconnectedcomputer.
Ittakesafewsecondsforachangeofyourcomputer'sIP
addresstocomeintoeffectinWindows7/WindowsVista
whileittakesoneortwominutesinWindowXP.
Whenyouconnectwithyourcomputertosaveyourprole
andselect"Automaticallyconnectwhenwithinrange"from
thePropertiestabofWirelessNetworkinWindowsforyour
selectedprole,yourwirelessLANwillbeaccessedunder
thefollowingconditions:
• atthetimeofturningonthecomputerortheprojec-
tor
• whenthenotebook type is within therangeof the
projector'swirelessLANcanbeachieved.
DatatransmissionbetweenwirelessLANandwiredLAN
isnotpossible.
Whenthe [SIMPLEACCESSPOINT] mode isused to
sendimages,itisrecommendedtoconnecttoonlyone
computer.
[PROFILE1] UptotwosettingsfortheUSBwirelessLANunitcanbe
storedinmemoryoftheprojector.(→page50)
Torecallthesettingsfrommemory,select[PROFILE1]or
[PROFILE2]from[PROFILE].
[PROFILE2]
[RECONNECT] Retrytoconnecttheprojectortoanetwork.Trythisifyouhavechanged[PROFILE].
NOTE:Afterselecting[EASYCONNECTION]from[PROFILE],youcannotmakesettingsto[DHCP],[IPADDRESS],[SUBNETMASK],
[GATEWAY],and[AUTODNS]except[CHANNEL].