NEC MD205MG-1 - On-Screen Display

English.7
English
On-Screen Display
Image setting
Brightness: Adjusts the overall image and background screen brightness.
Press “+” or “-” to adjust.
Note: When backlight sensor is enabled by “Light set” selections 2 ~ 5, this function is disabled.
Contrast: Adjusts the image brightness in relation to the background.
Press “+” or “-” to adjust.
Gamma setting
Gamma: Allows adjustment of monitor Gamma (Grayscale tone curve).
There are six selections.
1: Gamma off Native Gamma.
2: Gamma 1.8 Sets the Gamma value to 1.8
3: Gamma 2.0 Sets the Gamma value to 2.0
4: Gamma 2.2 Sets the Gamma value to 2.2
5: Gamma DICOM Factory calibrated DICOM GSDF (Grayscale Standard Display Function)
is active.
6: Gamma User Programmable gamma curve is active for NEC GammaCompMD software
calibration.
BackLight sensor setting
Light set: Sets the output luminance of the monitor.
Continuous brightness stabilization setting.
There are five selections.
1: Light off No backlight stabilization.
2: Light 300 Sets brightness to 300cd/m
2
3: Light 400 Sets brightness to 400cd/m
2
(Recommended setting for optimal product lifetime and performance)
4: Light 500 Sets brightness to 500cd/m
2
5: Light 600 Sets brightness to 600cd/m
2
System Information
Sys Info: Provides information about the current resolution and technical data.
Includes: Horizontal and Vertical frequencies, Display resolution, The name of MCU&FPGA,
MCU (Micro Controller Unit) version (Mver) and FPGA (Field Programmable Gate Array)
version (Fver)
OSD rotate & language setting
OSD Rotation: To switch OSD between landscape and portrait mode.
1 (Normal): Landscape mode
2 (Rotation): Portrait mode
OSD language: OSD control menus are available in seven languages.
Press “<“ or “>” to select.
1: English
2: Japanese
3: German
4: French
5: Italian
6: Spanish
7: Swedish
Misc
Reset All: Selecting Reset allows you to reset all OSD control settings.
OSD Lock Out: This control locks out access to all OSD control functions. When attempting to activate OSD controls
while in the Lock Out mode, a screen will appear indicating that the OSD controls are locked out.
To activate the OSD Lock Out function, press ENTER and hold down for at least 5 seconds.
To deactivate the OSD Lock Out function, press ENTER and hold down for at least 5 seconds while in
the OSD menu. No controls can be adjusted while in the lock out mode.
OSD Warning
No Sync: This function gives a warning when there is no Horizontal or vertical Sync.
After power is turned on or when there is a change of input signal, the No Sync window will appear.
01_MD205MG-1_INSTALL_EN.P65 7/5/08, 10:09 AM7