English-18
OSD TOOL
LANGUAGE
Selects the language used by the OSD.
OSD TURN OFF
The OSD menu will stay on as long as it is in use. You can select how long the monitor waits after the last key touch to
shut off the OSD menu. The preset choices are 10-120 seconds by 5-second increments.
OSD LOCK OUT
This control completely locks out the access to all OSD control functions except for [VOLUME], [BRIGHTNESS] and
[CONTRAST].
To activate the [OSD LOCK OUT] function, enter the [OSD TOOL] sub menu, select [OSD LOCK OUT], touch and hold
the INPUT/RESET and + keys simultaneously until “OSD LOCKED OUT” indicator appears.
To deactivate, touch the SELECT key, then repeat the same steps until the OSD main menu displays on screen.
SIGNAL INFORMATION
If you select [ON], the monitor displays “VIDEO INPUT” after changing the input.
NOTE: The compliance marks that are shown when powering on the monitor the first time are not shown when
switching inputs.
The compliance marks are not shown again unless the AC power cord has been disconnected and
reconnected.
If you select [OFF], the monitor does not display “VIDEO INPUT” after changing the input.
NOTE: Setting [OFF] also prevents the compliance marks from being shown when powering on the monitor.
OSD Warning
OSD warning message close by touching the SELECT key.
NO SIGNAL: This function gives a warning when there is no signal present. After power is turned on or when there is a
change of input signal or video is inactive, the “NO SIGNAL” window will appear.
OUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. After the power
is turned on or there is a change of input signal or the video signal doesn’t have proper timing, the “OUT OF RANGE”
message will appear.
To Next Page
Loading...
Need help?
General