English−38
USB Selects a transfer speed of USB-C.
USB2.0: The maximum transfer speed is equivalent to USB 2.0 (up to 480 Mbps).
USB3.0: The maximum transfer speed is equivalent to USB 3.0 (up to 5 Gbps).
To avoid data loss, before changing the setting, ensure that no USB storage devices are in use
by the operating system.
USB Functionality Selects how power through the USB Type-A port and USB Type-C port, input signal from USB-C, and
external communication of USB are enabled in relation to the monitor’s power status.
• Actual power consumption depends on the connected USB device even when the monitor’s
power is off.
• To avoid data loss, before changing the setting, ensure that no USB storage devices are in
use by the operating system.
• When turning on the monitor or after FACTORY PRESET or [USB Functionality] is set to
[Off], USB Functionality message is shown when a USB-C cable is connected to the monitor.
Please select a setting.
Auto Depending on the monitor’s power condition.
On Always working even when the monitor is in power save mode or power off.
Off All USB functions (include USB Type-C video signal) are disabled.
USB LAN Turns the LAN port [On] or [Off].
When using the LAN port, set this [On]. Please refer to “LAN connection” (see page 22).
FACTORY PRESET Resets all OSD control settings back to the default settings except [Language].
Input Select Selects the input signal source.
Auto, HDMI, DisplayPort, USB-C.
Audio Mute Mutes the speaker or headphone output.
Audio Volume Controls the volume of the speakers or headphones.
DDC/CI Turns the [DDC/CI] function [On] or [Off].
This function gives a warning when there is no horizontal or vertical sync. After power is turned on or when there is a
change of input signal, the window will appear. The message will close automatically.
This function gives a recommendation of the optimized resolution and refresh rate. After the power is turned on,
or there is a change of input signal, or if the video signal doesn’t have proper timing, the message will appear.
To close the message, please disconnect signal cables.
This function noties of the increase in
power consumption. The message appears when adjusting [DV MODE], [Brightness], or [ECO MODE] settings.
To change the setting, select [Yes] in the message window and press the key.
To return without changing, select [No] in the message window and press the key.
This message gives a request to set [USB Functionality] setting. See “USB Functionality” above.
To Next Page
Loading...
