English - 14
Mounting (for Customer)
WARNING Please refer to “WARNING 7”, “WARNING 8”, “WARNING 9”, and “WARNING 12”.
Contact your supplier as they may be able to provide a list of qualied installation professionals. Mounting the product on a wall
or ceiling and hiring a technician are the customer’s responsibility.
Maintenance
• Periodically check for loose screws, gaps, distortions, or other problems that may occur with the mounting equipment. If a
problem is detected, refer to the qualied personnel or the supplier for service.
• Depending on the environment, the mounting location may weaken due to natural degradation. Regularly ask the qualied
personnel to inspect the mounting location and carry out maintenance.
Prevent Tipping
WARNING Please refer to “WARNING 7” and “WARNING 9”.
Before attaching the monitor to the wall, make sure that the wall can support the weight of the monitor.
Changing the Logo Ornament Position
When using the monitor in the portrait position, the logo ornament position can be changed.
Removing the logo ornament Unscrew the installed screw then take off the logo ornament.
Attaching the logo ornament Make sure the holes for the screws on the logo ornament and the holes for the
screws on the bezel are aligned. Install the logo ornament with the screws, which are used for installing the logo
ornament. (Recommended Fasten Force: 30-40 N•cm).
NOTE: Do not use any other screw to install the logo ornament.
To Next Page
Loading...
Need help?
General