23
Tag 8
continued
OSM LOCKOUT
continued
2: OSM LOCK OUT with no control: This mode prevents access
to all OSM functions. To activate, press the SELECT and
“Right” buttons simultaneously. To deactivate, press the SELECT
and “Right” buttons simultaneously, while in the OSM menu.
3: OSM LOCK OUT with BRIGHTNESS (only) control: This
mode locks all OSM functions except for BRIGHTNESS.
To activate, press the SELECT, “Left” and “Down” buttons
simultaneously, while in the OSM menu.
To deactivate, press SELECT, “Left” and “Down” buttons
simultaneously, while in the OSM menu.
4: CUSTOM: Press RESET and EXIT to enter the CUSTOM
Menu. Select ENABLE or DISABLE for: POWER KEY, INPUT
SEL, HOT KEY, BRIGHTNESS/CONTRAST, ECO MODE,
WARNING, RESOLUTION NOTIFIER/OSM LOCK OUT.
To Deactivate the OSM Lock Out function, press RESET and
EXIT to bring up the LOCK OUT warning. Press SELECT,
SELECT, <, >, <, >, EXIT.
OSM
TRANSPARENCY
Adjusts the transparency of the OSM MENU.
OSM COLOR “Tag window frame color”, “Item select color”& ”Adjust Win-
dow frame color” can be changed.
SIGNAL
INFORMATION
Signal information can be displayed in the corner of the screen.
Signal information is either “ON/OFF”.
RESOLUTION
NOTIFIER
The Resolution Notifi er warns the user if the input to the monitor
is set to something other than the optimized resolution of
1280 x 1024. If the monitor detects a signal that is not at the
optimized resolution, after 30 seconds a warning message will
appear on the screen. The Resolution Notifi er is set to ON by
default.
HOT KEY When this function is activated, the brightness and contrast of
the monitor can be adjusted without entering the OSM menu by
using the front buttons.
The “Left” or “Right” buttons adjust the brightness level.
The “Down” or Up” buttons adjust the contrast level.
FACTORY PRESET Selecting the factory preset allows the user to reset most of the
OSM control settings back to the factory settings.
Individual settings can be reset by highlighting the control need-
ing to be reset, and pressing the RESET button.
Tag 9 GRAYSCALE
MODE
This mode changes the display’s screen image from color to
grayscale.
There are 3 settings for monochrome mode.
OFF: The display’s screen image is normal.
MODE1: The monitor uses only the Green component of the
RGB color input signal to display grayscale.
MODE2: The monitor converts the RGB color input signal to
YUV to display the image as grayscale.
Advanced OSM Controls - continued
To Next Page
Loading...
Need help?
General