NEC NP-CR5450H - Page 27

27
7. NETWORK SETTINGS
9. After completing required settings, focus on [OK] and press the ENTER button.
Back to the [SECURITY] page.
10. Select [OK] and press the ENTER button.
Back to the [ADVANCED] setting screen.
Thiswillcompletesetting[EAP-TLS]for[EAPTYPE]in[WPA-EAP]or[WPA2-EAP].
TIP:
Clearing the digital certificate that is installed on the projector
To clear the digital certificate installed on the projector, follow the steps below.
By doing the following procedure, all the digital certificates for the currently displayed profile will be cleared.
1. Focus on [CLEAR CERTIFICATES] at the bottom of the [ADVANCED] setting screen and press the ENTER
button.
A message for confirmation will be displayed.
2. Focus on [YES] and press the ENTER button.
The digital certificates will be cleared.
② Selecting [PEAP-MSCHAPV2] for [EAP TYPE]:
3. From the [AUTHENTICATION] page, focus on [EAP TYPE] field and press the ENTER button.
The pull-down list will be displayed.
4. Focus on [PEAP-MSCHAPV2] and press the ENTER button.
5. Focus on [USER NAME] field and press the ENTER button.
The character entry screen (software keyboard) will be displayed. Set a user name.
• Ausernamemustbe32charactersorless.
6. After completing setting a user name, focus on the [PASSWORD] field and press the ENTER button.
The character entry screen (software keyboard) will be displayed. Set a password.
• Apasswordmustbe32charactersorless.
• Youcanselecteither"Usethecerticate"or"Notusethecerticate" forPEAP-MSCHAPV2.Forusingthe
certicate,setat"Usethecerticate",ontheotherhand,ifyoudonotusethecerticate,setat"Notusethe
certicate".
7. After completing setting the password, focus on [CA CERTIFICATE] field and press the ENTER button.
The drive list screen will be displayed.
• Toreturntothe[AUTHENTICATION]page,presstheEXITbutton.
NOTE:
Installing a digital certificate
Youcaninstalleach digitalcerticate(clientcerticateandCAcerticate) for[PROFILE 1(or2)]onale-by-le
basis.
• InstallarootCAcerticateforaCAcerticate.
• Ifyouinstalladigitalcerticateoveryourexistingdigitalcerticate,theexistingdigitalcerticatewillbeoverwrittenwiththenew
digitalcerticate.
• Onceadigitalcerticatehasbeeninstalled,itsinformationcannotbedeletedevenifyoustopsettingWPA2-EAP,WPA/WPA2-
EAP.
8. On the [FILES] screen, focus on a digital certificate (DER format file) saved in your USB memory device
and press the ENTER button.
The selected digital certificate will be installed on the projector.