NEC NP-CR5450H - Date and Time; Administrator Mode; Default App

34
8. TOOLS
8-3. DATE AND TIME
Set the current date and time in this device.
Item Description Remarks
Time zone settings Set the time difference with UTC (Universal Time, Coordi-
nated) and the region where this device is used.
Thedefaultvalueis“+00:00”.
Example: When using the
deviceinJapan,setitto
“+09:00”.
Dateandtimeset-
tings
Set the current date and time. Synchronize with the NTP
serveronthenetworkandputacheckmarkin“Internet
TimeServer”toobtainthecorrecttime.ThenentertheIP
address or host name of the NTP server to perform updat-
ing.
The default date is
“01/01/2015”(Thu).Thede-
faulttimeis“00:00”.
Summer time set-
ting
Set summer time. When Enable is checked, summer time
is enabled. Set the various time differences and the start
and end of summer time.
Important:
• Whenusingtheclockfunctionofthisdevice,leavethedeviceinthestandbymodeifitisnotgoingtobeused.
 Iftheprojectorleavesforovertwoweekswithoutthepowersupply,thesetdateandtimewillberesettothefactorydefaultsetting
andtheclockfunctionwillbecomeineffective.Whentheclockfunctionbecomesineffective,set"Dateandtime"again.
NOTE:
• IfdateandtimeisresetaroundthetimingofstartingornishingSummertime,Summertimesettingmaynotbecomeeffective
properly.
 Incasedateandtimeisrequiredtoreset,performthesettingsinorderofTIMEZONE→DATEANDTIMESETTING→SUMMER
TIME.
8-4. ADMINISTRATOR MODE
Select the menu mode of this device, enable/disable the saving of settings of the entire projector, and configure thep-
assword setting in the administrator mode.
Item Description Remarks
Menu mode Select the basic menu or advanced menu. See the user's
manual of the projector for the items that can be used in the
respective menus.
Donotsavetheset-
tings
Put a check mark if you are not saving the value of the con-
figured item in the on-screen menu.
No check mark as the factory
default setting.
New password / Con-
firm new password
Set the password in the administrator mode.
Amaximumof10alphanumeric
characters.
8-5. DEFAULT APP
Omit to display the application menu and select the start-up function either when the APPS button on the remote
control is pressed, or [APPS] is selected as the input terminal on the onscreen menu.
Item Description Remarks
Defaultapplication When the projector is turned on under the condition of being
selectedthe"APPS"terminal,selectfunctioneithertheAPPS
MENU or the viewer.
The default factory setting is
“APPSMENU”.