NEC NP-CR5450H - Image Express Utility; Network Service

29
7. NETWORK SETTINGS
7-5. IMAGE EXPRESS UTILITY
CongurethesettingswhenusingImageExpressUtilityLite.
Item Description Remarks
Mode Select the operating mode.
Free: Set the free mode.
Control: Set the managed mode.
The default factory setting when
shippedis“Free”.
HTTP Password Abletosetupapasswordtolog in theMANAGEDMODE
for the IMAGEEXPRESSUTILITY  in theWEBSERVER
functions
Max 32 alphanumeric charac-
ters. If it leaves in blank, the
passwordbecomes"Null".De-
fault setting: Blank
NOTE:
• Ifyouchangethesettingoftheoperatingmode,connectingtotheIMAGEEXPRESSUTILITY,itwillnotbereectedimmediately.
WhentheIMAGEEXPRESSUTILITYbecomesunusedcondition,thechangeintheoperatingmodewillbereected.
7-6. NETWORK SERVICE
AMX setting
IfyouconnectthisdevicetoanetworkcompatiblewiththeNetLinxcontrolsystemofAMXCorporation,youcanen-
able/disablethedetectionsettingfromAMXDeviceDiscovery.Acheckmarkisnotwhenthedeviceisrstshipped
from the factory.
SeethewebsiteofAMXCorporationformoreinformationonAMXDeviceDiscovery.
HTTP server configuration
SetthepasswordforloggingintothePROJECTORCONTROLscreen.Amaximumofupto10
alphanumeric characters can be set for the password.
PJLink setting
SettheloginpasswordforusingPJLink.Amaximumofupto32alphanumericcharacterscanbesetforthepass-
word.
Alert e-mail setting
When using this device connected to a network, computers and other devices will be notified of the status of this
device via e-mail if the lamp of this device is due for replacement, or if an error occurs.
ALERTMAIL This option will notify your computer of lamp replace time or error messages via e-mail
whenusingwiredLAN.
Placing a checkmark will turn on the Alert Mail feature.
Clearing a checkmark will turn off the Alert Mail feature.
Sample of a message to be sent from the projector:
THECOOLINGFANHASSTOPPED.
[INFORMATION]
PROJECTORNAME:PJ-XXXXXXXX
LIGHTHOURSUSED:XXXX[H]
SENDER’SADDRESS Entersender’saddress.
SMTP SERVER NAME Enter the SMTP server name to be connected to the projector.
RECIPIENT’S ADDRESS
1, 2, 3
Enteryourrecipient’saddress.Uptothreeaddressescanbeentered.