119
7. Maintenance
2. Loosen the two screws securing the lamp housing until the phillips screwdriver goes into a freewheeling
condition. The two screws are not removable.
Remove the lamp housing by holding it.
NOTE: There is an interlock on this case to prevent the risk of electrical shock. Do not attempt to circumvent this interlock.
3. Insert a new lamp housing until the lamp housing is plugged into the socket.
CAUTION
Do not use a lamp other than the NEC replacement lamp NP06LP.
Order this from your NEC dealer.
Secure it in place with the two screws.
Be sure to tighten the screws.
Interlock
To Next Page
Loading...
