NEC PA803UL - Page 125

108
5. Using On-Screen Menu
Conditions for using tiling
• All the projectors need to full the following conditions.
• The panel size must be the same
• The projection screen size must be the same
• The left and right ends or top and bottom ends of the projection screen must be consistent.
• The settings for the left and right edges of the edge blending are the same
• The settings for the top and bottom edges of the edge blending are the same
If the tiling conditions are satised, the video screen of the projector at each installation position will be automati-
cally extracted and projected.
If the tiling conditions are not satised, adjust the video screen of the projector at each installation position using
the zoom function.
• Assign a unique control ID to each projector.
• Set the “Color setting” and “DeepColor setting” on your Blu-ray player or computer to “Auto”. Refer to the owner’s
manual accompanied with your Blu-ray player or computer for more information. Connect an HDMI output signal
of your Blu-ray player or computer to the rst projector and then connect to the HDBaseT OUT/Ethernet port on
the rst projector to the HDBaseT IN/Ethernet port on the second projector, same to the sequel projectors..
Tiling setting example) Number of horizontal units = 2, Number of vertical units = 2
Horizontal order = Second unit
Vertical order = First unit