SL1100 Installation Instructions
1-888-632-3794 • info@necsl1100distributors.com
2
3. For this example your router should either be plugged directly into a modem OR not plugged into a
modem at all. AT NO POINT should your router be plugged into another router! The Router is only
being used to assign IP addresses for PC Pro programming purposes.
4. Turn on the NEC SL1100 and wait for the phones and KSU to power up (approx. 3-5 minutes).
5. Go to any phone and press the Menu Key, then 96. (The Menu Key is the unmarked Circular Button
on the lower right corner on the front of the phone)
6. Press Menu again to display the System IP Address.
7. Write down the IP address. This will be the IP Address used in PC Pro to connect to the phone
system.
SYSTEM IP ADDRESS: ________________________________
Part 2: Connecting to the SL1100 with the PC PRO System Administrator
1. Open the PC Pro System Administrator on the computer that is connected to the same router as the
phone system.
2. Click the Connect Button in the upper left-hand corner.
3. Under Connection Type, Enter the SYSTEM IP Address you wrote down during Part 1.
4. Enter the User Name: sltech (all lower case with no spaces).
5. Enter the Password: 12345678 (no spaces or other characters).
6. Click connect.
SL1100 S
STEM IP Address from Part 1
To Next Page
Loading...
