NEC SL2100 - 2.2 Adjusting the Angle of the Tilt Legs

Issue 1.0
SL2100 DT920 (ITK-8LCX) User Guide 3
2.2 Adjusting the Angle of the Tilt Legs
2.2.1 Adjust Angle of Tilt Legs
1. Turn the terminal over (key side down).
2. Adjust the legs to the desired height (upward to raise the height /
downward to lower the height.
3. Turn the terminal over (key side up).
2.2.2 Raise the Height of the Tilt Legs:
The height can be adjusted by moving the legs, which are attached to the
bottom of the terminal.
Figure 3 Adjust the Tilt Leg Angle
Figure 4 Adjust the Tilt Leg Height