NEC Storage M110 - Installing and Setting Up Software; Preparation for Software Setup; Specifying IP Address; Installing Storage Manager Agent Utility

Installing and Setting Up the Software
4-1 Configuring NEC Storage Manager
7-1
Preparation
4-3-1 Installing Network Setting Tool
7-2
Specifying the IP address
4-4 Installing NEC Storage Manager Agent Utility on Application Server
7-3
Installing NEC Storage Manager Agent Utility
Install the software required to prepare and set up the NEC Storage Manager client.
Install the network setup tool and then specify the IP address for the disk array. See the following sections:
Prepare the client machine on which NEC Storage Manager client will be used. See the following section:
Install NEC Storage Manager Agent Utility on the application server. See the following section:
7-4
Starting NEC Storage Manager client
Start the NEC Storage Manager client on the client machine. See the following section:
７
4-2 Configuring Internet Explorer and Java for NEC Storage Manager
4-3-2 Configuring IP Addresses by Using Network Setting Tool
4-3-3 Setting the Disk Array Unit Time Zone
4-5 Starting NEC Storage Manager Client