Chapter 3 Operation Settings
126
(3) RPL_WAITMSG
• Specify whether to output the following wait process messages when the -wait option of
the iSMrc_replicate, iSMrc_separate, or iSMrc_restore command is
specified and when the iSMrc_wait command is issued.
- The “Replicating...” message output by the iSMrc_replicate command
- The “Separating...” message output by the iSMrc_separate command
- The “Restoring...” message output by the iSMrc_restore command
- The “Waiting...” message output by the iSMrc_wait command
• One of the following can be specified:
UNUSE Does not output a wait process message.
USE Outputs a wait process message. This is the default value when
this environment variable is not specified.
An environment variable regarding the Separate function (RPL_SEP_RVUSE)
Specifies operations during Separate execution conducted by the iSMrc_separate command.
• Specify operations conducted when the -rvuse option is omitted or when the default
value is specified in the -rvuse option.
• One of the following can be specified:
IMMEDIATE After Separate execution, the RV is immediately available while the
difference between the MV and RV contents is being reflected into
the RV. To use this function, you need to purchase “NEC Storage
DynamicDataReplication Ver2” and release the license lock of the
product.
COMPLETE After Separate execution, the RV becomes available when the
difference between the MV and RV contents has been reflected into
the RV. This is the default value when this environment variable is
not specified.
An environment variable regarding the Restore function (RPL_RST_MODE)
Specifies operations during Restore execution conducted by the iSMrc_restore command.
• Specify operations conducted when the -mode option is omitted or when the default
value is specified in the -mode option.
• One of the following can be specified:
UPDATE Performs Restore while reflecting the updated data of the MV into
the RV. When the Restore is completed, the state changes to Sync
State (rst/sync). This is the default value when this environment
variable is not specified.
PROTECT Performs Restore without reflecting the updated data of the MV into
the RV. When the Restore is completed, Separate is automatically
executed and then the state changes to the Separated state. To use
To Next Page
Loading...
