NEC UNIVERGE DT930 - Page 63

OPERATION
53
9. After input the number data, Press system soft
key (SET).
If it is not necessary to register the dial
number just press Enter or system soft
key (SET) without entering the dial
number.
When returning to the previous screen,
press up key or system soft key
(CANCEL).
When erasing a character, press left or
soft key (BK).
10. After complete the input data, press system soft
key (OK).
11. Press Back key.
Return back to the idle screen.
TO EDIT
Following explains how to edit the registered data.
1. Refer to “TO SEARCH PERSON” and display the
person information to edit.
2. Press system soft key “ENTRY”.
You will receive a dial tone.
Speaker key lamp lights red.
Line key lamp lights green.
3. Edit the data you want change.
Refer to “TO REGISTER” procedure 4.-
about how to input the data.