Chapter 10 System Input/Output (I/O) Interfaces
Page 10-10 UNIVERGE NEAX 2000 IPS
Request for Proposal (RFP) Reference Guide
Issue 6
Service Conditions
1. Only one Interface Port can be provided for PMS.
2. The system sends information relating to the following features to the PMS upon request from the
PMS:
Do Not Disturb
Room Cut-off
3. The
UNIVERGE NEAX 2000 IPS system can support PMS Model-60 via AP00-B or PMS Model
90/120 via TCP/IP connection.
4. The AP00-B with MRC-F program is used for Executed task Print out Request for MP Built-in PMS.
Hardware Required for PMS
Description Qty Remarks
SPN-CP24-C MP (UA) 1 per system MP
SPN-AP00B MRC-C (AP) 1 per system Control card for PMS Note
SPN-AP00B MRC-F (AP) 1 per system Executed Task Print Out for MP PMS Note
PZ-M606-A (ETHER) 1 per system MP Mounted card One per MP
RS RVS-4S CA-C 1 per SMDR/PMS AP00-VMS, 13.1ft (4.0m)
RS NORM-4S CA-A 1 per SMDR/PMS AP00-MODEM, 13.1ft (4.0m)
RS PRT-4S CA-A 1 per Printer AP00 Printer
PMS Terminal Serial 1 per system Model 60 only
PMS Terminal over IP 1 per system Model 90/Model 120
SMDR Terminal 1 per system
Printer As required
MODEM As required
Note: Only one AP00 at a time can be mounted in the system.
To Next Page
Loading...
