Chapter 13 Voice Over IP (VoIP)
Page 13- 14 UNIVERGE NEAX 2000 IPS
Request for Proposal (RFP) Reference Guide
Issue 6
Required Equipment for IP Station
Equipment Name Function
PZ-M606-A On board Ethernet Interface card. One per system
SPN-32IPLAA IP PAD 32ch IP Interface card for IP PAD
SPN-16VCTAA IP PAD
16ch Codec card for IP PAD Compression
Max. 2 per 32IPLA Card (optional)
SPN-8IPLA IP PAD 8ch IP PAD card w/compression
PZ-24IPLA 24ch Expansion card for IP PAD. Mounts on 8IPLA.
IPW-2U Unit IP Adapter Unit for Dterm Series E terminals
IP-R Unit IP Adapter Unit for Dterm Series i terminals
AC-R Unit AC/DC Adapter for Dterm Series i terminals
ACA-U Unit AC/DC Adapter for Dterm Series E terminals
IP Terminals
DtermIP terminals
Dterm Series i/E terminals w/IP adapter
INASET terminals
SP30/SP30 ACD Softphones
Power
For Powering the IP stations use one of the following:
AC power supply (ACA-U)
SN1604 Power Hub
Cisco Catalyst switch power feed
CCIS Networking via IP
This feature provides CCIS networks with Voice over IP (VoIP) capabilities to provide a
converged infrastructure over corporate Wide Area Networks (WAN). The IP Enabled Dterm
can communicate with other IP Enabled Dterm over the CCIS network (IP based) on a peer-to-
peer connection basis. The legacy terminals (TDM based terminals) can communicate with
other legacy terminals or IP Enabled Dterm terminals over the CCIS network via IP Packet
Assembler/Disassembler (IP-PAD). Voice compression of G.729a (8 kbps) and G.723.1 (5.3
kbps / 6.3 kbps) is available for those connections. The CCIS Networking via IP provides users
with all TDM-based CCIS functionality, such as feature transparency, centralized
management, and centralized facilities.
There are two types of connections available for CCIS Networking via IP:
To Next Page
Loading...
