Chapter 14 Common Channel Inter-Office Signaling (CCIS)
UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide Page 14-19
Issue 6
Required Equipment
Required Equipment for Digital CCIS
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
PN-24CCTA
CCT
CCIS (1.5 Mbps) Trunk Card
Provides a built-in Common Channel Handler (CCH) of CCIS.
PN-24DTA-C
DTI
T1 Digital Trunk Interface (1.5 Mbps) Card
Accommodates 24-channel PCM digital lines.
PN-30DTC-C
DTI
E1 Digital Trunk Interface (2 Mbps) Card
Accommodates 30-channel PCM digital lines.
PN-SC00
CCH
Common Channel Handler Card
Transmits/receives signals on the common signaling channel of
CCIS.
PN-M10
M10
Optical Fiber Interface Card
Provides optical fiber interface for T1/E1 Digital Trunk Interface
(1.5 M/2 Mbps) Line length: 6.2 miles (10 km) or less
Line coding: CMI
Required Equipment for Analog CCIS
EQUIPMENT
NAME
FUNCTIONAL
NAME
FUNCTION
PN-SC00
CCH
Common Channel Handler Card
Transmits/receives signals on the common signaling
channel of CCIS.
PN-2ODTA
ODT
2-line Out Band Dialing Trunk Card
Used as either a 2-wire E&M trunk or a 4-wire E&M
trunk.
Equipped with –48V DC-DC on-board power supply.
Both Circuits 0 and 1 must be set to the same
purpose
(2-wire or 4-wire) in one card.
Required Equipment for CCIS Networking via IP
Description Remarks
CCIS via IP (non Peer-to-Peer)
SPN-IPTB Network Interface:
ETHER/FAST ETHER
SPN-4VCTI Codec Card for IP Trunk
CCIS via IP (Peer-to-Peer)
PZ-M606-A On board Ethernet Interface Card
(ETHERNET TCP/IP)
SPN-8IPLA IP PAD-C IP Interface card for IP Pad
PZ-24IPLA 24-channel daughter board for 8IPLA
To Next Page
Loading...
