UNIVERGE NEAX 2000 IPS
Request For Proposal (RFP) Reference Guide Page 3-1
Issue 6
Chapter 3 System Highlights
Processors
The UNIVERGE NEAX 2000 IPS, IPS DM, IPS DML and IPS DMR are distributed
multiprocessor systems. Their control system consists of a Main Processor (MP), Firmware
Processors (FP), and Application Processors (AP). Both the FP and APs execute their
predetermined functions under the control of the MP.
Main Processor (MP)
Name Code Remarks
PN-CP24-C
Main Processor Card for
UNIVERGE NEAX 2000 IPS and IPS DM
.
One card is required per system.
PN-CP27-A
Main Processor Card for
UNIVERGE NEAX 2000 IPS Dual MP System.
One card is required per system.
Main Processor Card for UNIVERGE NEAX IPS DML
One card is required per system.(Stand Alone system or CCIS end point)
PN-CP31-C
Main Processor Card for
UNIVERGE NEAX IPS DMR
.
One card is required for each Remote Site.
PZ-M606
Ethernet Control Card:
• Mounted on MP card to accommodate the Ethernet and transmit/receive a signal
of TCP/IP protocol.
• 10 BASE-T/100 BASE-TX twisted pair cable is connected directly to this card.
To Next Page
Loading...
