NEC UNIVERGE NEAX 2000 IPS - Page 24

Chapter 1 Introduction
Page 1-18 UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
Issue 6
IPS System Capacity (Single MP System cont’d)
Capacity Per PIM Note
Item
PIM1 PIM2 PIM3 PIM4 PIM5 PIM6 PIM7 PIM8
Attendant Terminal (Dterm ATT Position) Max. 8 sets per system
SMDR Interface
Max. 2 Interface ports (RS232)
Max 1 interface port (IP) per system
PMS Interface
Max. 1 Interface port (RS232)
Max 1 interface port (IP) per system
ACD / MIS or OAI Interface Max. 1 interface port per system
Remote PIM over IP (Number of PIM for Remote
Sites)
Up to 30 (depending on network)
DID Dial Conversion 1000
Call Forwarding-Outside Set 496
Authorization. Code / Forced Account Code /
Remote Access to System(DISA)Code
3000
Message Reminder Set 1024
Name Display / Guest Name Display 512
Speed Calling-Station (Station Speed Dial) Set 10000
MP built-in SMDR Call Record 1024
Note: System Capacity is for Main site only. For Total System Capacity see IP Remote Network System
Capacity.