EasyManua.ls Logo

NEC UNIVERGE NEAX 2000 IPS - Page 76

NEC UNIVERGE NEAX 2000 IPS
389 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 4 Equipment List
Page 4- 4 NEAX2000 IPS
Request For Proposal (RFP) Reference Guide
Issue 6
Common Control Cards (Cont.)
PN-CP31 MP
Main Processor Card for Remote PIM (DML/DMR)
Provides LAN control function, System-based Device Registration Server
(DRS), built-in FP, 33 MHz PCI BUS, Memory (SDRAM 64 MB, Flash ROM
16 MB), TDSW (1024CH × 1024CH), 16-line CFT, PB sender, Clock, 2-line
PLO (receiver mode/source mode), one RS-232C port, 4-line PB receiver,
internal Music-on-Hold tone, BUS interface.
BUS interface functions as a driver/receiver of various signals, adjusts gate
delay timing, cable delay timing, monitors I/O Bus and PCM BUS.
Supports MP Program Download.
One card is required per system.
PN-CP15 FP
Firmware Processor Card for the IPS.
Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-module BUS
interface. BUS interface functions as a driver/receiver of various signals,
adjusts gate delay timing, cable delay timing, monitors I/O Bus and PCM
BUS. When the system consists of three PIM’s or more, one each of this card
is mounted respectively in PIM2, PIM4, and PIM6.
3/4 PIM System: 1 per System
5/6 PIM System: 2 per System
7/8 PIM System: 3 per System
PZ-M606 ETHER
Ethernet Card, 1 per MP
For Peer to Peer Connection and MAT/OAI
Mounted on MP card to accommodate the Ethernet and transmit/receive a
signal of TCP/IP protocol. Provides Auto Negotiation function (Always set to
ON). 10 BASE-T/100 BASE-TX cable is connected directly to this card.
PN-PW00 EXTPWR
Power Supply Card for DESKCON
Provides –48 V DC power.
Maximum 3 cards per PIM. One card per two Desk cons
Occupies two physical slots width per card.
PZ-PW121
AC/DC
PWR
Main Power Supply Card
Input: AC120 V/240 V (50 Hz/60 Hz)
Output: –27 V (4.4 A), +5 V (7.2 A), CR (38 mA), +90 V (80 mA)
One card is pre-installed per PIM.
PZ-PW122
DC/DC
PWR
Power Supply Card for CS (ZT) and PN-4LLCB for Long Line
Input: –24 V DC
Output: –48 V DC (1.7 A)
One card per PIM.
Maximum 16 ZT’s per card. Requires Ferrite Core for Long Line function

Table of Contents

Other manuals for NEC UNIVERGE NEAX 2000 IPS

Related product manuals