Chapter 4 Equipment List
Page 4- 8 NEAX2000 IPS
Request For Proposal (RFP) Reference Guide
Issue 6
Line/Trunk (LT) Cards
The following table shows a summary of the Line/Trunk (LT) cards for UNIVERGE NEAX 2000 IPS. The
LT cards may be installed in slot 00 to 11 of PIM 0-7, with the following conditions:
Line/Trunk (LT) Cards
Function Name Port Remarks
PN-8LCAA
8
8 Line Analog Station Card
Message Waiting Control: 8 circuits
Momentary Open: 8 circuits
Loop Resistance: Max. 600ohms including
telephone set
PN-8LCAD 8
8 Line Analog Station Card
Caller-ID for Analog Station
Loop Resistance: Max. 600 ohms
Message Waiting Lamp control
Momentary Open for each circuit
PN-8LCS
8
8 Line Analog Station Card
Momentary Open: 8 circuits, Message
Waiting notification via Stutter Dial
Tone only.
Loop Resistance: Max. 600 ohms
PN-4LCD-A
4
4 Line Analog Station Card with MW Lamp
control, Momentary Open: 4 Circuits
On-Board power (80V) is included.
Loop Resistance: Max. 600ohms including
telephone set
PN-AUCA 2
2 Line Analog Universal Trunk
2 Line Long Line Circuit with PFT
Loop resistance: max. 2500ohms (LLC)
Two reverse circuits is included
On Board power (-48V) is included
Analog Station
PN-4LLCB 4
4 Long Line Analog Station Card
Works in either mode:
Long Line Station (Requires Ferrite Core)
Caller ID (Requires PN-4RSTF-A)
Loop Resistance:
Max. 2500ohms including telephone set
PZ-PW122 is required.
Can not be used in IPS DM or IPS DMR
To Next Page
Loading...
