EasyManua.ls Logo

NEC UNIVERGE SV9100 DT930 - Terminal Setup; Adjusting Volumes

NEC UNIVERGE SV9100 DT930
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
1.
2 Terminal Setup
This chapter describes basic operating procedures for
the terminal. Various terminal operations such as
display, sounds, password and backup and restore are
available.
Adjusting Volumes
Below is an example of the display when volumes are
being adjusted.
Adjust Handset Receiver Volume
It is possible to adjust the volume level of
handset receiver during a call in progress while
using handset.
To adjust the volume, press the UP or DOWN
key while off-hook or during a call using the
handset.
Adjust Speaker Volume
It is possible to adjust the volume level of speaker
during a call in progress using speaker. To adjust the
volume, press UP or DOWN key during speaker phone
operation or during a call using the speaker.
You can only adjust the volume on the Call
screen and Line screen.
When setting up the terminal, the softkey
indicates the local softkey.
If the Back/Exit button is pressed while the
Terminal Setting menu is displayed, the
Favorite screen is displayed regardless of
Home screen settings.
UP
DOWN

Table of Contents

Related product manuals