NEC Univerge SV9100 - Page 53

39
1.
(4) Select DTMF Tone.
Select an item by one of the following operations.
❍ Highlight an item by using , and press ,
or OK.
❍ Press .
(5) Select Automatic, Disable or Enable
(see the following table).
Select an item by one of the following operations.
❍ Highlight an item by using , and press or
OK.
❍ Press - , and press or OK.
2
2
0
1
2
Menu Items Description
0 Automatic
Follow the system settings. If no setting is
made in the system, the default setting
(DTMF=ON) is applied.
1 Disable Follow the terminal settings (OFF).
2 Enable Follow the terminal settings (ON).
TIP
For the setting on the system, contact the System
Administrator.
TIP
Default setting is Automatic.
TIP
The enabled item is highlighted.
0
2