NEC Univerge SV9100 - Page 59

45
1.
(4) Select Local Volume.
Select an item by one of the following operations.
❍ Highlight an item by using , and press ,
or OK.
❍ Press .
(5) Make a selection from the following list.
Select an item by one of the following operations.
❍ Highlight an item by using , and press or
OK.
❍ Press - , and press or OK.
Note: When 0 Automatic is set, the default setting (Enable)
is applied.
2
2
Menu Items Description
0 Automatic Each volume level is displayed on LCD.
1 Disable Each volume level is not displayed on LCD.
2 Enable Each volume level is displayed on LCD.
TIP
Default setting is Automatic.
TIP
The enabled item is highlighted.
0
2