NEC Univerge SV9100 - Section 2 DTI Specifications; Chapter 3 System Data Programming <US Only>; Section 1 K-CCIS Programming; Chapter 3 General IP Configuration

Placing an Outside Call…
Press a line key for
quick access:
1. (Optional) Lift handset.
2. + Listen for dial tone + Outside number.
• You can have function keys for lines or line groups.
OR
Dial codes for outside
lines:
1. or Lift handset.
2. 9 ( ) + Outside number.
OR
2. 8 0 4( ) + Line group (1-9 or 001-100) + Outside number.
OR
2. 8 0 5( )+ Line number (e.g., 005 for line 5) + Outside number.
Calling a Co-Worker…
Dial using the
intercom:
1. or Lift handset.
• For one-touch calling, press a One Touch Key or DSS function key
instead of going on to step
2.
+ Co-worker’s extension number.
• Your call will ring or voice-announce. If you hear ringing, wait for an
answer. If you hear a beep, begin speaking. Dialling 1 changes
voice/ring mode.
• For your Voice Mailbox, dial 717.
• For Paging, dial 801( )+ 0 for All Call or 801( ) + 1-64 for zones.
Placing Calls