UM8000 Issue No. 1.0
Installation Manual 6 - 3
Perform the following procedure to install the CD-VM00.
1. Wear a grounding strap while handling the CD-VM00 and DSP. Lay the compo-
nents on a flat work surface.
2. Mount the CR-2032 battery with the “+” side up in the “BATT” slot on the
CD-VM00. Refer to Figure 6-2 Install the CR-2032 Battery on page 6-3.
3. To install the SO-DIMM memory on the CD-VM00 blade, insert the end with the
brass connectors into the CN14 1 slot. Then, push the other end down until the
locks on both sides lock into place. Refer to Figure 6-3 Install the SO-DIMM
Memory on page 6-3.
Figure 6-2 Install the CR-2032 Battery
Figure 6-3 Install the SO-DIMM Memory
To Next Page
Loading...
