USB connection
----------------------------------------------------------------------
This conforms to the USB1.1 standard.
Transfer speed: All speeds (supported)
Endpoint: Control transfer Endpoint 0
Device class: HID class (Ver1.1)
USB1.1 Standard: Universal Serial Bus Specification Revision 1.1
HID : Human Interface Device
Connector Specifications
1 VBUS (Power supply)
2 D- (- Signal)
3 D+ (+ Signal)
4 GND (Ground)
* Depending on the USB host controller in the personal computer, the USB connection may fail to operate.
When using a USB hub, please use a self-powered type, not a bus-powered type. When using a USB hub,
connection to the first stage of the USB hub is recommended.
LAN connection
----------------------------------------------------------------------
[ Wired LAN port ]
LAN interface
Communication speed: Auto setting (10/100Mbps)
Certified standard: IEEE802.3 (10BASE-T)
IEEE802.3u (100BASE-TX, Auto-Negotiation)
A LAN connector (8 male RJ-45 connector)
1 TD+ Transmit data (+)
2 TD- Transmit data (-)
3 RD+ Receive data (+)
4 Not used
5 Not used
6 RD- Receive data (-)
7 Not used
8 Not used
[ Wired/wireless LAN card ]
The LAN connections will differ depending on the commercial LAN card that is used.
- For information on supported LAN cards, visit:
Global: http://www.nec-pj.com/
[Port Number]
To Next Page
Loading...
