12
THREADING UPPER LOOPER
1. Feed the thread through the thread
guide as illustrated.
2. Pull the upper thread through the
tension control.
3. Draw the thread through the thread
guide as illustrated.
4. Pass the thread through wire thread
guide and looper eye, leaving an excess
length of about 4"(10 cm) .
3
4
2
1
When using normal or thin thread.
When using thick thread.
4XDQGRXVDWHXQILODWRQRUPDOH
RVRWWLOH
4XDQGRXVDWHXQ
ILODWRSHVDQWH
,1),/$5(,/*$1&,2
683(5,25(
)DWHSDVVDUHLOILORDWWUDYHUVR
LOJXLGDILORFRPHLOOXVWUDWR
7LUDWHLOILORDWWUDYHUVRLGLVFKL
GHOERWWRQHWHQVLRQH
)DWHSDVVDUHLOILORDWWUDYHUVR
LOJXLGDILORFRPHLOOXVWUDWR
)DWHSDVVDUHLOILORDWWUDYHUVRJXLGDILOR
PHWDOOLFRHRFFKLHOORGHOJDQFLR
ODVFLDQGROLEHULFLUFDFP
GLILOR
To Next Page
Loading...