Necci Lock 160 - Helpful Hints

14
1
2
3
HELPFUL HINTS
REPLACING THREAD SPOOLS
When replacing thread spools, the following steps may be
helpful for quick changeover.
1. Cut off existing threads near the spools. Tie the cut ends
thread from new spools as illustrated (seamen's knot).
2. Raise presser foot and turn all tension controls to 0.
3. Lower needle bar to its lowest position by turning hand
wheel away from you. Carefully pull the existing thread
one by one until the connecting knots pass through
needle eye and looper eye.
4. Reset the tension controls.
CUTTING NEEDLE THREAD
Frayed thread may make needle threading difficult.
Draw the thread near the thread cutter on the needle plate
and push the thread cutter lever (Model 056 only) or draw
the thread passing under the moving cutter and turn hand
wheel towards you to obtain clear cut end as illustrated.
68**(5,0(17,87,/,
6267,78=,21(632/(),/$72
4XDQGRVLVRVWLWXLVFRQHOHVSROHGLILODWRLVHJXHQWL
SDVVDJJLFRQVHQWRQRXQFDPELRYHORFH
7DJOLDWHLILOLHVLVWHQWLYLFLQRDOOHVSROH/HJDWH
OHHVWUHPLWjGLILORWDJOLDWHDOOHQXRYHVSROH
FRPHLOOXVWUDWRQRGRPDULQDLR
3RVL]LRQDWHWXWWLLERWWRQLFRQWUROORWHQVLRQH
VX
3RUWDWHODEDUUDDJRQHOODSRVL]LRQHSLEDVVDUXRWDQGR
LOYRODQWLQRYHUVRGLYRL7LUDWHLILOLHVLVWHQWL
ILQFKqLQRGLGLDOODFFLDPHQWRSDVVDQR
DWWUDYHUVRODFUXQDGHJOLDJKLHODFUXQDGHL
JDQFL
5HLPSRVWDWHLYDORULGLWHQVLRQH
7$*/,$5(,/),/2'(//$*2
8QILODWRVILODFFLDWRSXzUHQGHUHGLIILFROWRVDOLQILODWXUD
GHOODJR
7LUDWHLOILORVRWWRDOFROWHOORPRELOH
HUXRWDWHLOYRODQWLQRYHUVRGLYRLSHURWWHQHUHWDJOL
QHWWL