Instructions
for Installer,
Maintenance Engineer
and final User
SINFONIA
Rev. 00
H4345 - 00 02/2013 Page 9 of 41
3.2 Characteristics of Installation Area
CAUTION: THE MACHINE IS NOT SUITABLE FOR OUTDOOR INSTALLATION
CAUTION: DO NOT USE JETS OF WATER TO CLEAN VENDOR, DO NOT PLACE THE
VENDOR IN AREAS WHERE JETS OF WATER ARE USED
Environmental conditions for installing vendor
• “Mod. GF6-GF9-DR6-DR9” vendors must be installed in an area/room where temperature does not
exceed 32 °C or fall below 10 °C, otherwise the ele ctric parts (compressor) could overheat or
malfunction.
• The air circulation is very important for the cooling unit, check that there is a 10 cm gap between the
rear of the vendor and the obstacle (wall).
• Check that the surface where the vendor is placed supports the weight of the machine.
3.3 Removing of Wooden Bases
To remove wooden bases, work as follows:
• W
ith a transpallet lift the machine from the floor (holding it from the Front)
• With an adjustable wrench unscrew the screws that fasten the wooden base to the machine: 2
screws on the right hand side and 2 screws on the left hand side
• Assemble the 4 feet on the base of the machine
• Place the machine on the floor
3.4 Levelling
In order to have the best working conditions place the vendor on a perfectly levelled surface. Any
irregularities on the floor can be compensate by adjusting the screw-on feet on the vending machine to
obtain a perfect levelling and guarantee stability.
THE BEST PERFORMANCE IS GUARANTEED IF THE VENDOR IS PLACED ON A HORIZONTAL
SURFACE
To Next Page
Loading...
