Vaping Oils (CBD/Thick oils)
7
06
Pre-Heating Function
05
Using/Changing the Cartridges
Wait 5 minutes to ensure the coil is completely
soaked before using.
For best results, we recommend replacing the
cartridges with new cartridges after 5 uses.
04
Turning On
Press the power button 5 times in rapid succession
to turn on/off, the LED light will flash 5 times. If
using your device in cold temperatures or with thick
oils then see step 6 below for instructions on how
to pre-heat your oil.
Turn on the device and press the power button two
times rapidly for an automated 30 seconds preheat
before vaping. Press the button once to stop. In
preheat mode, the green LED lights will flash for
30s. Preheating will make your oil easier to vape.
For best results, draw on the device mouthpiece gently using smooth, slow and long tokes.
Always use the device in an upright or mostly-upright position.
To Next Page
Loading...