Place the Wax Pad into the Chamber
Heating the Concentrate/Wax
Adding extracts onto the pad
Operating Guide: Vaping Extracts
01
02
03
If recently used, allow your device to cool down before cleaning it to
ensure the chamber is free of any loose leaf and/or resin. Place the
provided extract/concentrate/wax pad into the chamber.
Place a small amount of extract onto the pad, roughly half a grain of
rice & gradually increase to the size of two grains of rice to find your
preferred amount.
Note: Too much wax may cause an overspill and block the airflow
holes.
Concentrates tend to have a higher boiling point than dry herbs so
set the temperature of your device to 230°C-240°C. Once your
device vibrates, wait an additional 20s and then take long, slow and
smooth tokes (each toke should last between 5-10s depending on
how strong you desire the hit to be).
9 10
To Next Page
Loading...
