TRANSIT Quick Installation Guide AMERICAS
Page 2 of 4
Page 2 of 4
Wiring
Power supply wiring
Fuente de Poder: 24 VDC +/- 10%, *500mA.
Especificaciones del Cabo: 2 x 1.5mm (2 x 15 AWG)
Longitud Maxima: 45 metros (140 ft.). de acuerdo con regulaciones en USA y Canada.
Wiegand Wiring
En la figura abajo el wiring de el wiegand protocolo es mostrado.
Longitud Maxima: 45 metros (140 ft.) de acuerdo con regulaciones en USA y Canada
Led Indicaciones
Un numero de LED’s es usado para indicar el estado actual. La tabla de abajo describe la function de cada LED.
LED Description
STS
Status
LED.
Blinking slow: System's heartbeat (0.8 sec on / 0.8 sec off). Indicates that the power is on
and the processor is running.
Blinking fast: Bootloader say's hello. Only indicated for a short period directly after a reset.
Blinking twice: Configuration menu active.
Off: Abnormal situation. Should never be off for longer than 1 second.
ID
Identification
LED.
This green
LED starts to blink fast when a valid transponder is identified.
The LED stays off when no (valid) transponder is identified.
UL
Unlock
LED.
The unlock
LED is normally off and goes on when a valid transponder is identified. The LED is
turned off when no transponder is identified anymore and the relay-hold-time has elapsed. This
LED can be connected to a Reflex or DC130 antenna.
There is also a relay contact present which has the same function.
NA
Lock
LED.
Red
LED indicating system standby. This LED is normally on and goes off when the unlock LED
goes on. This
LED can be connected to a Reflex of DC130 antenna.
INP /
DOOR
Input status
LED
This red
LED is on when the input contact is closed. The input is used as general-purpose input.
+5 VDC
-15 VDC
+15 VDC
Power LEDs
Led active indicates voltage is present
Locked PLL Locked Led active indicates PLL is Locked
RX
RX Level Led Bar indicating the received tag signal strength. This LED Bar may also indicate the
presence of radio interference.
To Next Page
Loading...
