Need help?Do you have a question about the Nedap uPASS Access and is the answer not in the manual?
General| Frequency | 860-960 MHz |
|---|---|
| IP Rating | IP65 |
| Material | Plastic housing |
| Technology | RFID |
| Connectivity | Wiegand, RS-232, RS-485, Ethernet |
| Operating Temperature | -20 to +60 °C |
| Storage Temperature | -40°C to +70°C |
Overview of available firmware versions and their key features, including Standard and OSDP.
Details the types of NEDAP formatted UHF tags supported by the reader, such as Wiegand and Magstripe.
Discusses security measures against tag cloning, including TID check, EPC passwords, and secure authentication.
Outlines safety precautions for installation and service by qualified personnel, emphasizing power disconnection.
Provides guidance on mounting the reader to various surfaces and details installation dimensions.
Illustrates the detection coverage area of the uPASS Access antenna and adjustable read range.
Specifies the DC power supply requirements (12-24V) and current consumption for the reader.
Details communication interfaces including RS485, USB, Wiegand, and Magstripe protocols.
Describes the 3 digital inputs (active low) for controlling LED/buzzer or general purpose use.
Details the 2 digital outputs, their function dependent on firmware, and output ratings.
Explains the internal tamper switch for dismounting indication and how to connect it to an alarm system.
Describes connecting the reader to NEDAP AEOS hardware using the Nedap antenna interface.
Covers the operating frequency band (860-960 MHz) and regional variations in regulations.
Explains how to manually select frequency channels for optimal performance using UHFTOOL.
Introduces the UHFTOOL software for reader configuration and firmware manual for protocol details.
Guides users on how to access and use the configuration sidebar within the UHFTOOL software.
Configures tag selection, access methods, data to read, and security checks for tag data.
Enables or disables decoding of Nedap-XS formatted tags and explains output formats.
Configures timing parameters like Tag hold time and RF off time, noting no relay output exists.
Details automatic and remote LED control for visual feedback, noting OSDP firmware limitations.
Accesses advanced configuration settings for experienced users via UHFTOOL.
Configures serial output settings, including event repetition and vehicle ID events.
Allows customization of the serial output message format, including prefix, suffix, and data fields.
Enables optional Wiegand or Magstripe output for non-standard tags and configures data source and format.
Displays the reader's operating frequency region and allows selecting a fixed frequency channel.
Configures the read range by adjusting the RSSI threshold (squelch) to filter tags by signal strength.
Provides instructions for updating the reader's firmware using UHFTOOL, including switching between firmwares.
To Next Page
