uPASS Access | installation guide
26/
5.3 Expert settings
Click 'Options', 'Usermode', 'Expert' to show additional configuration settings for advanced users.
5.3.1 Output
Configure communication output settings.
Figure 16: Output settings
Select 'Enable serial id-events' to enable the serial output upon identification.
When 'Fast repeat serial id-events' is selected (default) the serial output is repeated upon every identification. When
this option is disabled, the message is only transmitted once.
Enable 'Repeat using hold-time interval' to periodically repeat the id-events as long as the tag is within the
identification range. Set the hold-time to specify the interval between the repeated messages. The repeating will be
enabled for the serial and also for the Wiegand or Magstripe interface.
'Enable vehicle id-events' allows enabling or disabling the id-event messages for vehicle-ids. This may be useful in
combination with the NEDAP DUAL-ID mode and an access control panel that does not support the dual-id feature.
To Next Page
Loading...
