Nedap uPASS Access - Decode Nedap-XS

uPASS Access | installation guide
23/
33
5.2.2 Decode Nedap-XS
Enable/disable decode Nedap-XS formatted tags.
Figure 12: Decode Nedap-XS
By default, decode Nedap-XS is disabled. The data for Nedap-XS formatted tags will be transmitted to the NEDAP
antenna interface.
Enable decode Nedap-XS when you do not want to use the NEDAP antenna interface. The uPASS will decode the
Nedap-XS tag data and output its tag-number in readable format. You can also enable to output or verify the customer
code.
Enable the option 'Allow other tag formats' when you want the reader to support also other formatted tags, such as
NEDAP UHF Wiegand formatted tags and others.
The decoded Nedap-XS output number contains:
Byte 1: 4E NEDAP UHF
Byte 2: <FMT> FMT=01: Nedap-XS decoded hex tagno
FMT=02: Nedap-XS decoded decimal tagno.
Byte 3-4: 00 Unused
Byte 5-7: CC CC=Customer code (zero if not transmitted)
Byte 8-12: TAGNO TAGNO=Tag number
Examples:
NEDAP UHF XS: 4E10 3FFF C415 A87C BD51 8000
NEDAP UHF XS decoded: 4E01 0000 0000 0000 0000 3039
NEDAP UHF XS decoded decimal: 4E02 0000 0000 0000 0001 2345
NEDAP UHF XS decoded + custcode: 4E01 0000 0415 A000 0000 3039
NEDAP UHF XS decoded decimal + custcode: 4E02 0000 0415 A000 0001 2345