What to do if no project found on Neets OsCar Control Systems?
If no project is found on the Neets Control System, or you are unable to start the project, first try to upload the project again. Alternatively, there might be an issue within the uploaded project itself. In this case, attempt to upload an empty project to see if that resolves the problem.
How to fix unexpected error on Neets Control Systems?
If your Neets Control System encounters an unexpected error, turn off the power to the system for 20 seconds before turning it back on.
Why is Neets Control Systems resuming factory default settings?
The Neets control system will delete the current settings and resume factory default when Switch 1 and 2 are pressed during power on. This is only intended to be used if the control system locks up and enters 'Unexpected Error'.
Power| input voltage | 12 VDC |
|---|---|
| power usage | 1 W |
| power adaptor input voltage | 100 VAC – 240 VAC |
| line frequency | 50 Hz – 60 Hz |
| max power usage | 8 W |
Operating Environment| storage temperature | -20 °C to 50 °C |
|---|---|
| operation temperature | 0 °C to 30 °C |
| storage moisture | Non-condensing |
| operation moisture | Non-condensing |
Weight and Dimensions| width | 55 mm |
|---|---|
| height | 55 mm |
| depth | 17 mm |
| weight | 90 g |
| shipping weight | 0.3 kg |
| shipping dimension | 155x85x55 mm |
Power| input voltage | 12 VDC |
|---|---|
| power usage | 1 W |
| power adaptor input voltage | 100 VAC – 240 VAC |
| line frequency | 50 Hz – 60 Hz |
| max power usage | 8 W |
Operating Environment| storage temperature | -20 °C to 50 °C |
|---|---|
| operation temperature | 0 °C to 30 °C |
| storage moisture | Non-condensing |
| operation moisture | Non-condensing |
Weight and Dimensions| width | 45 mm |
|---|---|
| height | 72 mm |
| depth | 17 mm |
| weight | 90 g |
| shipping weight | 0.3 kg |
| shipping dimension | 155x85x55 mm |
Steps for installing the DK version of the OsCar control system into a back box or bracket.
Steps for installing the EU version of the OsCar control system into a back box or bracket.
Connects the OsCar to the universal mains AC power adaptor.
Onboard I/O ports for external devices like keyboards, sensors, or relays.
Configurable port for RS-232 communication or IR emitter.
Description of the four front panel buttons and their LED indicators.
Using the USB port for programming the OsCar with Neets Project Designer.
Guide to understanding error codes indicated by the OsCar's LEDs.
To Next Page