NEFF B47FS26G0 User Manual

Troubleshooting en
35
Fault Cause and troubleshooting
Appliance will not start or cuts
out during operation.
Malfunction
▶
Call the after-sales service.
→"Customer Service", Page37
The appliance is not heating;
appears on the display.
Demo mode is activated in the basic settings.
1.
Briefly disconnect the appliance from the power supply by switching the cir-
cuit breaker in the fuse box off and then on again.
2.
Deactivate Demo mode within the next 3 minutes in the
→"Basic settings", Page23.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance will perform a self-test, after which it will be ready to use.
Time not displayed when appli-
ance switched off.
Basic setting has been changed.
▶
Change the basic setting for the clock display.
→"Basic settings", Page23
HomeConnect is not working cor-
rectly.
Different causes are possible.
▶
Go to www.home-connect.com.
The control panel cannot be
opened.
The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Malfunction
1.
Call the after-sales service.
→"Customer Service", Page37
2.
If there is water in the water tank, empty the water tank:
‒ Open the appliance door.
‒ Grip on the right and left below the control panel.
‒ Slowly pull out the control panel and push it upwards.
Intense steam generation when
steaming.
The appliance is automatically calibrated.
No action required.
If the cooking times are too short, the appliance is not automatically calibrated.
If a lot of steam is generated repeatedly, the appliance is recalibrated.
1.
Reset the appliance to the factory setting.
→"Basic settings", Page23
2.
Repeat the calibrations.
→"Before using for the first time", Page11
Steam escaping from ventilation
slots during cooking
Escaping steam is not a fault.
No action required.
The appliance requests descaling
without the counter appearing in
advance.
The set water hardness range is too low.
1.
Descale the appliance.
→"Descaling", Page29
2.
Check the water hardness and set this in the basic settings.
→"Basic settings", Page23
The appliance prompts you to
rinse it.
During the descaling, the power supply is interrupted or the appliance is
switched off.
▶
Rinse the appliance twice.
→"Descaling", Page29
"Fill water tank" appears in the
display even though the water
tank has been filled.
The water tank has not clicked into place.
▶
Insert the water tank correctly so that it engages in the holder.
→"Filling the water tank", Page13
The water tank has fallen out. Shaking has caused parts to come loose in the
water tank. The water tank is leaking.
▶
Order a new water tank.
Malfunction
▶
Do not use deionised or filtered water.
→"Before using for the first time", Page11

NEFF B47FS26G0 Specifications

General

Brand	NEFF
Model	B47FS26G0
Category	Oven
Language	English