en Appliance door
26
18.3 Removing the door panes
To facilitate cleaning, you can remove the door pane.
WARNING‒Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
Requirement:The appliance door is detached.
→"Detaching the appliance door", Page23
1.
Lay the appliance door with the front side facing
down on a flat surface that is soft and clean.
2.
Push on the left- and right-hand side of the appli-
ance door from the outside until the inner pane is
released on both sides.
3.
Carefully lift the inner pane and remove it in the dir-
ection of the arrow .
4.
Push down on the intermediate pane in the area of
, and carefully lift the retainer until you are able
to pull it out.
5.
Lift the intermediate pane from below and remove
it in the direction of the arrow .
6.
WARNING‒Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
▶
Do not use glass scrapers, sharp or abrasive
cleaning aids, or harsh cleaning products.
Clean the door panes on both sides with glass
cleaner and a soft cloth.
7.
Dry the door panes and refit them.
→"Fitting the door panes", Page26
18.4 Fitting the door panes
WARNING‒Risk of injury!
If a door pane or appliance door has not been installed
correctly, this is dangerous.
▶
Make sure that all of the door panes and the appli-
ance door have been correctly fitted before you
switch the appliance back on again.
1.
Tip:When fitting the door panes, make sure that
they are in the original order.
Insert the intermediate pane in the direction of the
arrow and push it in in the direction of the arrow un-
til it is fitted in the frame.
The arrow on the intermediate pane must line up
with the arrow on the frame .
To Next Page
Loading...
Need help?
General
