18
Refitting
1.Insert the intermediate panel and push it downwards until it
engages. (Fig. A).
Note: Make sure that the panel is aligned evenly, at the
bottom.
2.The lettering must be positioned in the top right corner, so
that it can be easily read. (Fig. B).
3.Push the safety catches downwards. (Fig. C).
4.Insert the door panel into the guide with both hands. (Fig. D).
5.Push the door panel downwards, lift it slightly and hook it in
at the top. (Fig. E).
Make sure that the door panel is sitting flush with the control
panel.
6.Fully open the door, while holding the panels firmly with one
hand. (Fig. F).
7.Push the door downwards again and tighten the screws
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. G).
Caution!
The oven may only be used again when the panels are
correctly installed.
Note: The oven may only be used again when the panels are
correctly installed.
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
ã=Risk of electric shock!
■ Work on the appliance electronics may only be performed by
a specialist.
■ Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
To Next Page
Loading...
Need help?
General
