Operating the appliance en
7
Control panel model 2
Control panel
Setting the fan
Switching on
Pull out the filter pull-out and press the # button. The
fan starts at setting ƒ.
Press the + or - button to change the fan strength.
Switching off
Press the # button. Slide the filter pull-out in.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting „.
The intensive setting ˜‚ is activated. Pressing the +
button again activates the intensive setting ˜ƒ.
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Automatic mode
Switching on
■ Press the # button.
The fan starts at setting ƒ.
■ Press the ‘ button.
The optimum fan setting ‘‚, ‘ƒ or ‘„ is
automatically set via a sensor.
Switching off
Press the ‘ button or the # button to switch off
automatic mode.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
Automatic mode can run for a maximum of four hours.
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting fumes.
Depending on the sensor setting, the fan automatically
switches to another fan setting.
Default sensitivity setting: †
Lowest sensitivity setting: ‹
Highest sensitivity setting: Š
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
1. When the fan is switched off, press and hold the ‘
symbol for approx. four seconds. The setting is
displayed.
2. The sensor control setting is changed by pressing
the + or – button.
3. To confirm the entry, press and hold the ‘ symbol
for approximately four seconds.
Fan run-on time
Press the - button until – appears, or slide in the filter
pull-out.
After approx. 10 minutes, the fan switches off
automatically.
AirFresh function
Press the - button until 3‚ appears. The fan runs for
approx. five minutes per hour.
If you want to end the AirFresh function, press the #
button.
Noise reduction function
The noise reduction function reduces the fan noise.
Switching on the appliance
Press the 4 button.
The function is possible in all fan settings, except in fan
setting ‚. It also remains active after the fan is switched
off.
Switching off the appliance
Press the 4 button.
Lighting
The lighting can be switched on and off independently
of the fan.
Press the A button.
Setting the brightness
Press and hold the A button until the desired
brightness is reached.
Explanation
#
Fan on/off
4
Noise reduction
- Reduce the fan settings/fan run-on time/interval ventilation
+ Increase the fan settings/intensive mode 1, 2
‘
Automatic function
A
Light on/off/dimming
IUHVK
YRO
YRO
To Next Page
Loading...
Need help?
General
