NEFF I92C67N0 User Manual

Electrical connection
15
WARNING: THIS APPLIANCE MUST BE
EARTHED.
The appliance must be installed so that
p
lug is accessible.
IMPORTANT: Fitting a different plug.
The wires in the mains leads are coloured
in accor
dance with the following codes:
Green and Yellow – Earth
Bleu – Neutral
Brown – Live
If you fit your own plug, the colours of
these wires may not correspond with the
identifying marks on the plug terminals.
This is what you have to do.
1. Connect the green and yellow (Earth)
wire to the terminal in the plug market
“E “ or with the symbol (
), or
coloured green or green and yellow.
2. Connect the bleu (Neutral) wire to the
terminal in the plug marked ‘N’ or
coloured black.
3. Connect the brown (Live) wire to the
terminal marked “L” or coloured red.
The extractor hood should o
nly be
connected to an earthed socket that has
been installed according to relevant
regulations.
If possible, site the earthed socket directly
above the chimney panelling in the ceiling.
Electrical Data:
Are to be foun
d on the name plate inside
the appliance after removal of the filter
frame.
Before undertaking any repairs,
always disconnect the extractor hood from
the electricity supply.
Length of the connecting cable: 1,3 m.
If it is necessary to wire the extractor
hoo
d directly into the mains:
The extractor hood should only be
conn
ected to the electricity supply by a
properly qualified electrician.
A separator must be installed in the
household circuit. A suitable separator is a
switch that has a contact gap of more than
3 mm and interrupts all poles. Such
devices include circuit breakers and
contactors.
If the connection cable for this
appliance is damaged, the cable must be
replaced by the manufacturer or his
customer service or a similarly qualified
person in order to prevent serious inury to
the user.
This extractor corresponds to EC
regu
lations concerning RF interference
suppression.
Installation
The island extractor hood is desig
ned to
be fitted to the kitchen ceiling or a rigid
suspended ceiling.
Ensure that the minimum distance
between hotplate and extractor hood is
550 mm for electric hotplates and 650 mm
for gas hotplates.
Ensure that the inox surface is not
damaged.
Follow the mounting steps as shown in M
F
igures.

NEFF I92C67N0 Specifications

General

Brand	NEFF
Model	I92C67N0
Category	Ventilation Hood
Language	English