22
Replacing the light bulbs
1. Switch off the extractor hoo
d and pull
out the mains plug or switch off the
electricity supply at the fuse box
When switched on, the halogen bulbs
become very hot. Even for some time after
the bulbs have been switched off there is
stil a risk of burns.
2. F
ollows the steps shown in the L
Series for replacing the lamps.
3. Replace the damaged halogen light
bulb wth a new one with same
characteristics.
4. Plug the appliance into the mains or
switch it on at the fuse box.
Note: if the lig
ht does not function, check
that the bulbs have been inserted
correctly.
If you encounter a problem
If a
or appears in the display:
See “Filters and Maintenance“
Section.
If it is not possible to operate the
e
xtractor hood:
Disconnect the extractor hood from
the mains electricity supply by pulling
out the plug or switching it off at the
main fuse box. Wait for approx. 1
Minute and then switch it on again.
If the lights of the lamps is weak when the
hood is in stand-by, then invert the plug
(invert phase with neutral).
If you have any questions or if a fault
occurs, please
call Customer Service.
(see list of Customer Service
representatives).
When you call please quote the following:
E-Nr. FD
Enter the relevant numbers into the box
above. The E-Nr. (Product no.) and FD
(Production date) are shown on the
nameplace which can be seen inside the
extractor hood after the filter frame has
been detached.
The manufacturer of the extractor
hood accepts no liability for complaints
which can be attributed to the design
and layout of the pipework.
To Next Page
Loading...
Need help?
General
