16 Nektar Impact LX Mini owner’s manual www.nektartech.com
Setup mode
Program Assign
Program messages are used to change a program (also sometimes called preset or patch) on a receiving device. This type of message is
typically used on MIDI hardware, but in some cases it is also used to change sounds on software plugins.
Each of the assignable buttons and pads can be programmed to send a MIDI Program change message. You will need to know which
messages your receiving device expects to get this right, so make sure to consult the documentation available for that product.
• Press [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
• Press D1 on the keyboard to select Prg Assign.
• Move or press a control to select it for assignment.
• Enter a program value between 0-127, using the black number keys labelled 0-9.
• Press [Enter] (C3) to accept the change and exit Setup.
MIDI Channel Assign
value 0.
• Press [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
• Press D#1 on the keyboard to select MIDI Ch Assign.
• Move or press a control to select it for assignment.
• Enter a MIDI channel value between 0-16, using the black number keys labelled 0-9.
• Press [Enter] (C3) to accept the change and exit Setup.
Pad Learn
It’s easy to change a pad note assignment using the Pad Learn function. Try these steps:
• Press [Shift]+[Internal] to activate Setup mode. The Internal button’s LED now blinks white.
• On the keyboard, press E1, labeled ‘Pad Learn’.
• All pad LEDs are now off, except the currently select pad. Press any pad to select it.
• Press a key on the keyboard to learn its note to the selected pad. Use the octave buttons if necessary.
• Repeat the previous 2 steps to select pads and assign notes.
• Press [Instrument], [Internal] or [Function] to exit when done.
Save Pad Map
If a Pad Map is loaded, all current assignments will be replaced by the settings of the loaded Pad Map. To retain current settings, save to
one of the 4 Pad Map locations for recall at any time.
• Press [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
• Press F1 on the keyboard to select ‘Save Pad Map’. The 4 pads corresponding to Pad Maps 1-4 are now each illuminated in their
identifying color.
•
• Press [Enter] (C3) to save to the selected Pad Map location and exit Setup.
To Next Page
Loading...
Need help?
General
