15
NEMO GRABO | Operator’s manual
irritation or burns.
e) Do not use a battery or tool that
Damaged
or modied batteries may exhibit
unpredictable behaviour resulting in re,
explosion or risk of injury.
excessive temperature. Exposure to re
or temperature above 130°C/265 °F may
cause an explosion.
g) Follow all charging instructions and do
not charge the battery or tool outside
instructions. Charging improperly or at
temperatures outside the specied range
may damage the battery and increase the
risk of re.
6) SERVICE
a) Have your power tool serviced by
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
b) Never service a damaged battery. Service
of battery should only be performed by
the manufacturer or authorized service
providers.
VACUUM LIFTING DEVICE SAFETY WARNINGS
a) Do not deliberately try to rip the load
There is a risk
of the load crushing feet and hands and
damaging the object and tool.
b) Do not lift objects weighing more than
There is a risk that the
weight could fall o.
c) Risk of load crushing feet and hands and
damaging the object and tool. Do not
shake the tool while lifting, moving and
placing objects. Do not swing or shake
the load while lifting, moving and placing
objects. Do not use the tool when the
seal is worn out. Lift and carry the load
with uniform speed without sudden sharp
and strong movements.
d) Do not use the tool while the battery
charge is low. There is a risk of injury and
damage to the materials being lifted.
e) If the sealing force begins to noticeably
decrease while the battery is fully
charged, check the rubber foam seal for
wear and tear or damage. Do not attempt
to lift anything with the tool until you
have replaced the seal.
f) Use caution when lifting large thin
plastic, plywood, thin sheet metal
etc. Thin sheets bend and ex and can
unexpectedly change curvature above
limit and detach.
g) Do not attach the tool to surfaces
with visible puddles of water. Internal
components are not waterproof. If
water is sucked into the air ducts it can
cause permanent damage to the tool.
The NemoGRABO® is not waterproof
and therefore extreme caution should
be taken when using it in the rain or wet
conditions.
h) Do not drop the tool from heights above
If dropped by accident, inspect the seal
side lips for damage.
i) Do not place heavy objects on top of the
tool.
j) To avoid overheating, do not cover the
tool.
before transporting the tool and when
in storage. Be mindful that the tool is not
switched on accidently.
! WARNING! Weight may drop without
warning if the safety precautions are
not kept! The NemoGRABO® creates a
strong vacuum. In case the seal is broken
To Next Page
Loading...